Page 24 - Demo

DCDCONMS12%u00b0OALAPMX DCXDHUBRd%u00b0Designation DC DCX(1) APMX AE(2) CICT(3) OAL DCONMS DHUB RMPX%u00b0(4) MDN(5) MDX(6) Arbor kg MIID(7) TQ(8)FFQ4 D40-05-16-09 25.70 40.00 1.20 7.1 5 35.00 16.00 38.00 2.0 65.70 79.00 A 0.17 FFQ4 SOMT 090412T 2.0FFQ4 D50-07-22-09 35.70 50.00 1.20 7.1 7 40.00 22.00 48.00 1.5 85.70 99.00 A 0.36 FFQ4 SOMT 090412T 2.0FFQ4 D52-07-22-09 37.70 52.00 1.20 7.1 7 40.00 22.00 48.00 1.4 89.70 103.00 A 0.34 FFQ4 SOMT 090412T 2.0FFQ4 D63-08-22-09 48.70 63.00 1.20 7.1 8 45.00 22.00 48.00 1.1 111.70 125.00 A 0.49 FFQ4 SOMT 090412T 2.0%u2022 To generate a straight surface without cusps, the width of cut must not exceed DC %u2022 Radius for programming: for insert SOMT 2.5 mm, for insert SOMW 3 mm %u2022 When mounting insert SOMW, APMX=1.0 mm %u2022 For slot milling or machining with high tool overhang, the maximum depth of cut should be reduced by 50% (1) Cutting diameter maximum (2) Maximum plunging width (3) Number of inserts (4) Maximum ramping angle (5) Machinable diameter minimum for interpolation (6) Machinable diameter maximum for interpolation (7) Master insert identification (8) Recommended tightening torque (Nm) for insert screw Spare PartsDesignationFFQ4 D40-05-16-09 SR M3X0.5-L7.4 IP9(a) IP-9/151 SR M8X25DIN912FFQ4 D50-07-22-09 SR M3X0.5-L7.4 IP9(a) IP-9/151 SR M10X25 DIN912FFQ4 D52-07-22-09 SR M3X0.5-L7.4 IP9(a) IP-9/151 SR M10X25 DIN912FFQ4 D63-08-22-09 SR M3X0.5-L7.4 IP9(a) IP-9/151 SR M10X30 DIN912FFQ4 D-09Fast Feed Face Mills Carrying Single-Sided Square Inserts with 4 Cutting Edges24 FAST FEED MILLING